DTF Station Transfer Film (Warm Peel) for Direct to Film 11.75" x 16.5" - 200 Sheets

Features:

After baking the powder, solid white for more vibrant colors. Even and regular particles for the fine quality of graphic and good adherence. Finely coated film for no pinholes!

Process:

1. Print the image onto the matte side of the film in mirror mode. (CMYK>>White Ink)
2. Apply hot melt powder evenly and remove the excess powder. Use a Seismo Shaker unit - like the Seismo S20 - to apply powder with ease!
3. Hover with a heat press to bake the hot melt powder (340°F, 5min). Or use a curing oven (300-315 °F, 1min).
4. Transfer the image by heat press at 330°F for 15sec with medium pressure.
5. After the first press, Option 1: Wait for 4-6 seconds and remove the film gently. Option 2: Rub the top surface with a cloth to remove some heat and peel off the film gently.
6. Heat press again at 330°F 5-10sec with medium pressure to enhance softer hand feel.

Warning:

Powder should NOT be applied on the printer platen. It needs to be applied AWAY from the printer. Application near the printer increases the risk of printer damage if the printer "breathes" in the adhesive powder into the intake fan by the electronics near the back of the machine. Damage to the printer for inappropriate use may not be covered under warranty.

Please wear Personal Protective Equipment (eyeglasses, mask, and gloves) when working with DTF products. The fumes from curing the powder can be hazardous.

Note:

• DTF (Direct To Film) products works with almost all types of fabrics including 100% polyester with good quality results!
• Transfer Film does not require pre-treatment and it uses minimum 75% less DTG inks on to get good quality.
• The designed fabrics or printed shirts have a good wash characteristic.
• The fabric has very slight hand feel touch.
• The process is much faster than Vinyl printing (Vinyl Printer).