GFP 5200 Removeable Adhesive Vinyl - 3mil Gloss w/air egress Calendered (polymeric) 54" x 150' Roll

White Adhesive Backed Vinyl - Gloss Finish Removable Adhesive

High sheen reflects light for bright, sharp details and eye-catching prints.

Printed PVC must be allowed to dry for 24-48 hours at 70° F prior to lamination to allow the residual solvent to evaporate. Failure to do so may result in delamination, tunneling, and shrinkage of the PVC and or adhesive failure.
 
The amount of dry time required is a function of the amount of ink applied, the image printed, relative humidity, printing conditions, etc., and all prints are not the same nor dry at the same rate. There may still be solvent in the ink that has not completely dried at the time of lamination. Although all PVC outgases, in some cases this process is accelerated by the presence of excess solvent in the ink and heat from high UV exposure.
 
These Durability estimates are based on accelerated aging tests and outdoor exposure, under conditions experienced in vertical exposure and in "normal" temperate climates. Exposure to severe humidity and ultraviolet light as in the Southern States or desert regions will cause rapid deterioration. This also applies to polluted areas, high altitude, horizontal and/ or south-facing exposure where durability may be divided by 2. Because of these varying climate conditions, there is no standard outdoor life durability; it is only a reference for choosing the proper product.

Important Notice
GFP products are warranted to be free from defects in material and workmanship (see GFP Product Warranty statement). Product information is based on research the company believes to be reliable; however, such information is given without guarantee and does not constitute a warranty. Purchasers should undertake their own evaluation of the product prior to use to independently determine the suitability of the product to their specific application and the purchaser shall assume all risks regarding such use.