Nekoosa 4mil Double-Polished Clear Walk-On Floor Graphic Overlaminate with Permanent Adhesive 54"x150' Roll

The Walk-On Graphics® two part system includes a printable vinyl base film and a UL 410 approved slip resistant overlaminate to create durable floor graphic applications.

Print Compatibility: Wide Format (Solvent, Eco-Solvent, Latex and UV), Offset (Conventional and UV) and Screen

Product Information

• Recommended for use on smooth, clean, flat surfaces like tile, sealed wood, ceramic tile vinyl and sealed concrete
• 4 mil. printable vinyl base film available in white or clear finishes with removable adhesive
• 4 mil. clear double polished and 6 mil. clear embossed UL410 certified overlaminates options
• Suitable for indoor short-term floor graphics (<6 months)
• Graphics withstand normal floor maintenance and cleaning
• Made in the U.S.A.
• Vinyl base film and overlaminates are available in standard 54"x50 yd. rolls for wide format printing
• Custom sheet and rolls for offset and screen printing available upon request

Applications

• Wayward Floor Graphics
• Floor Advertising Graphics
• P.O.P. Floor Signage
• Counter Mats
• Social Distancing Floor Graphics
• Directional Arrows

Applying Walk-On Graphics

Remove the release liner from the back of the graphic and position it on the desired location of the floor. Lift one edge of the decal. with a squeegee, use overlapping strokes to apply pressure from the middle towards the edge of the decal.

If the decal is large, it is recommended to spray the floor with water mixed with a few drops of liquid soap and follow the above procedure. It is very important that all edges and corners are applied with firm pressure. When more than one panel is used, butt the edge together. Never overlap decals.

After application is completed, do not polish decal or surrounding floor for 24 hours. If the edges lift at all from the floor, the decal must be removed immediately and replaced. This is to prevent any accidents or tripping.

Maintenance

Walk-On Graphics should be maintained using normal floor maintenance procedures.

Removal

Remove the Walk-On Graphics decal by lifting one edge and pulling at a sharp angle, using short, sharp strokes until the decal is up. If the decal is applied to a waxed floor, it is recommended that the floor should be rewaxed.