GFP Clear Mount 1mil 51"x150' Roll 3" Core

Clear Mount – 0.9 mil (23µ) Clear Polyester carrier coated two sides with clear 1 mil (25µ) solvent adhesive: one adheres to the back of a printed image, the other to a mounting board. It bonds the image to paper covered boards like Gatorfoam®, but forms a superior bond to low energy plastic surfaces like polystyrene, Sintra®, Gatorboard, and Ultraboard™. The single release liner is 75# (110 gsm) white paper coated both sides with moisture stabilizing PE and siliconized on the release side. Recommended for decaling printed images or pre-coating boards prior to mounting.

Mounting Adhesive is suitable for short to medium term indoor or outdoor signage on flat or slightly curved surfaces with vertical exposure and application temperatures of 40° F to 176° F. Bond strength is dependent upon the amount of adhesive to the mounting surface contact that is developed. Firm application pressure and moderate heat will assist the adhesive in developing contact with the mounting surface. For optimum 
adhesive, the mounting surface must be clean and dry. 

Durability estimates do not apply to the printed image. They are based on accelerated aging tests and outdoor exposure, under conditions experienced in vertical exposure and in “normal” temperate climates. Exposure to severe humidity and ultraviolet light as in Southern States or desert regions will cause rapid deterioration. This also applies to polluted areas, high altitude, horizontal and/ or south-facing exposure. Because of these varying climate conditions there is no standard outdoor life durability; it is only a reference for choosing the proper product. 

Important Notice 
Gfp products are warranted to be free from defects in material and workmanship (see Gfp Product Warranty statement). Product information is based on research the company believes to be reliable; however, such information is given without guarantee and does not constitute a warranty. Purchasers should undertake their own evaluation of the product prior to use to independently determine the suitability of the product to their specific application and the purchaser shall assume all risks regarding such use.